SyNergy_Mat Lab

Honaramooz, Mohammad Taha, MSc
Education:
Jan 2020 – June 2023Ph.D., Montanuniverstät Leoben Chair of Physics PhD topic: Dispersoid Formation and Distribution in 7xxx aluminium Ingots (Effect on recrystallization, microstructure, texture, and residual stresses of 7xxx plates) .
SEP 2015 - Nov 2017 Iran University of Science and Technology Materials Engineering, Characterization, and selection of Engineering Materials Master thesis: the effect of heat treatment parameters on the mechanical properties of Al-Li 2198 alloy B.Sc., Iran University of Science and Technology Materials Engineering
Sep 2010 - Sep 2015 B.Sc., Iran University of Science and Technology Materials Engineering
Projects: Research Assistant Montanuniverstät Leoben, Chair of Physics • Characterization of Al3Zr dispersoids in binary Al-Zr alloys (Role: Mentor) • Heat treatment of Al-Cu-Mg-based alloys (Role: data analysis, mentor)
Jan 2015- April 2019: Research Assistant Iran University of Science and Technology, Materials Engineering department • Effect of infrared heating and cryogenic treatment on the mechanical properties and residual stress of Al-Cu-Mg AA2024 alloy • Studying the third generation of Al-Li alloys • Investigating the wear resistance of A356/Fe-C composites • Improving wear resistance of a low-carbon steel
Mar 2013- May 2013 :Internship Title: Investigation of damage conditions, application and requirements for improvement of Abadan refinery's wet electrostatic precipitator Role: studying the corrosion resistance of duplex stainless steels and select the most promising steel
Publications
A comparison of small-angle scattering with electron microscopy techniques to characterize low volume fractions of heterogeneously distributed precipitates in alloys
Honaramooz, Mohammad Taha / SyNergy_Mat Lab
The characterization of Zr-containing dispersoids in aluminum alloys is challenging due to their broad size distribution, low volume fraction, and heterogeneous distribution within the grains. In this work, small-angle X-ray scattering (SAXS) and small-angle neutron scattering (SANS) were compared to scanning electron microscopy (SEM) and transmission electron microscopy (TEM) regarding their capability to characterize Zr-containing dispersoids in aluminum alloys. It was demonstrated that both scattering techniques are suitable tools to characterize dispersoids in a multiphase industrial aluminum alloy. While SAXS is more sensitive than SANS due to the high electron density of Zr, SANS has the advantage of being able to probe a much larger sample volume. The combination of SAXS and SANS allows for the verification that the dispersoids can be separated from other precipitate phases. The size distribution obtained from SAXS, SANS and TEM showed good agreement. The SEM-derived size distributions were, however, found to significantly deviate from those of the other techniques, which can be explained by considering the resolution-limited restrictions of the different techniques